Feature

Easier setup and operation-The pre-selection of nominal values for welding current, arc voltage and speed in coordination with the power source, and automatically configure the system for proper operation. The easy-to-understand interface provides the operator with the necessary controls to set process parameters and control output.

Flexible and adjustable -The welding head also has adjustment to angle forward or backwards by up to 45 degrees & side to side by up to 45 degrees.

Tracking Function - All welding heads are equipped with a laser pointer and a mechanical pointer for visual seam tracking. Via a cross support, the AH-1 can be manually positioned with an effective adjusting range of 100mm each.

Additional Gear Sets included - Used to change the speed ratio to match the requirements of your application.

Closed Loop Speed Control - Facilitates full control over starting, running and stopping wire feed speed.

Standard Accessories - Including an adjustable wire straightener, cross-seam adjuster and electrical valve flux hopper and mounting bracket for carriage.

AH-1

• Built-in wire straightener ensures stable and continuous wire feeding and reduces contact tip wear;

• Equipped with automatic arc ignition and burn-back function to optimize the welding process;

• The feed head can adjust the angle 45° (up and down, left and right, front and back).

AH-2

• Mainly suitable for fine wire welding;

• Wire Diameter: 1.2-3.2 mm;

• Feeding speed: 1.0-11 m/min.

AH-3
Strip welding feed head

• 60*0.5mm/0.3mm;

• Submerged arc strip cladding is an ideal choice for cladding or large-area welding of pressure vessels, and can provide high deposition efficiency;

• Weldable area per hour (1 /h), combined with low penetration and high brightness;

• Mainly used for surfacing welding of carbon steel, alloy steel and stainless steel.